Xe2delphi 102 Tokyo Full Source Install __hot__: Unigmap 148

This is not a standard or publicly available package. If you have the original installer or forum link, that’s your best path. Otherwise, look for modern mapping libraries with full source support.

This error occurs if the IDE cannot find the component's compiled source code during project compilation.

| Element | Meaning | |---------|---------| | unigmap | Likely a typo or very obscure component | | 148 | Unknown; maybe version or post ID | | xe2delphi102 | Delphi XE2 + Delphi 10.2 Tokyo | | full source install | Wants compilable source code for both versions |

uniGMap is offered free of charge. The author, , encourages users to share improvements and even to send a postcard as a token of appreciation. Because the component is community‑driven, the best support channels are: unigmap 148 xe2delphi 102 tokyo full source install

Delete these files from your system directories, specifically checking: C:\Users\Public\Documents\Embarcadero\Studio\19.0\Bpl C:\Windows\System32 and C:\Windows\SysWOW64 Step 2: Configure Environment Paths in Delphi 10.2 Tokyo

Verify that the folder structure contains the following essential subdirectories:

Right-click the (e.g., UniGMap_D.dpk ) and click Compile . This is not a standard or publicly available package

Design-time Packages ( dcl_dac250.dproj , dcl_unidac250.dproj ) Use the MSBuild command structure: msbuild dac250.dproj /t:Build /p:Config=Release Use code with caution.

Extract the UniGMap 1.4.8 source zip file to a permanent location on your drive (e.g., C:\Componentes\UniGMap\ ). Inside this folder, create two sub-folders: \Source : Place all .pas and .dcr files here.

Ensure that Delphi knows where to look for your source files. 🛠️ Step-by-Step Full Source Installation This error occurs if the IDE cannot find

Related search suggestions (Note: these suggestions are provided to help refine searches you might run externally.)

Open the design-time package file (typically named with a d suffix, such as ddac250.dpk or dunidac250.dpk ).

procedure TForm1.FormCreate(Sender: TObject); begin UniGMap1.Active := True; end; Use code with caution.