Follow the on-screen setup prompts and reboot your computer when finished. Method B: Manual Manual Installation (.inf)
Set to Enabled to distribute network traffic processing across multiple CPU cores. Troubleshooting Common Driver Issues Issue 1: "Code 10 - This device cannot start"
10 Mbps, 100 Mbps, and 1000 Mbps (Gigabit Ethernet) mtek g24101mkg network card driver full
Click , select the extracted driver folder, and ensure "Include subfolders" is checked.
Extract the contents of the zip file to a designated folder on your hard drive. Follow the on-screen setup prompts and reboot your
Completely uninstall the driver from Device Manager, power down your PC, unplug it, and physically re-seat the network card into a different PCIe slot. Reboot and attempt a clean installation of the full driver package. Issue: Connection is limited to 100 Mbps instead of 1 Gbps
The hardware is Gigabit capable, but Windows limits status speeds to 100 Mbps. Extract the contents of the zip file to
The M-Tek G24101MKG component is most frequently used on legacy setups running Windows XP, Windows 7, or older Linux kernels. If you are running Windows 10 or 11, you may need to right-click the installation executable, go to Properties , and run it under Compatibility Mode for an older version of Windows.
The MTEK G24101MKG is a reliable Gigabit Ethernet networking integrated circuit (IC) frequently found on desktop motherboards, PCI Express network interface cards, and specialized industrial computing equipment. To achieve maximum throughput, low latency, and connection stability, you must install the correct hardware driver.
Before downloading anything, you must find out which company manufactured the actual Ethernet controller chip on your board. Method A: Physical Inspection (Recommended for Legacy PCs) Turn off your computer and open the side panel.
The two most probable candidates are:
Follow the on-screen setup prompts and reboot your computer when finished. Method B: Manual Manual Installation (.inf)
Set to Enabled to distribute network traffic processing across multiple CPU cores. Troubleshooting Common Driver Issues Issue 1: "Code 10 - This device cannot start"
10 Mbps, 100 Mbps, and 1000 Mbps (Gigabit Ethernet)
Click , select the extracted driver folder, and ensure "Include subfolders" is checked.
Extract the contents of the zip file to a designated folder on your hard drive.
Completely uninstall the driver from Device Manager, power down your PC, unplug it, and physically re-seat the network card into a different PCIe slot. Reboot and attempt a clean installation of the full driver package. Issue: Connection is limited to 100 Mbps instead of 1 Gbps
The hardware is Gigabit capable, but Windows limits status speeds to 100 Mbps.
The M-Tek G24101MKG component is most frequently used on legacy setups running Windows XP, Windows 7, or older Linux kernels. If you are running Windows 10 or 11, you may need to right-click the installation executable, go to Properties , and run it under Compatibility Mode for an older version of Windows.
The MTEK G24101MKG is a reliable Gigabit Ethernet networking integrated circuit (IC) frequently found on desktop motherboards, PCI Express network interface cards, and specialized industrial computing equipment. To achieve maximum throughput, low latency, and connection stability, you must install the correct hardware driver.
Before downloading anything, you must find out which company manufactured the actual Ethernet controller chip on your board. Method A: Physical Inspection (Recommended for Legacy PCs) Turn off your computer and open the side panel.
The two most probable candidates are:
