Configure the communication baud rate for Port 2 (e.g., 9600, 19200, 38400, or 115200 bps).
Place a jumper across J7 if you are utilizing an external cabinet tamper switch. Step 3: Mounting and Wiring the Controller
By default, the LNL-3300-M5 is configured to request an IP address via DHCP. If a DHCP server is not available, it defaults to a static APIPA address or requires initialization through specialized configuration software. Assigning a Static IP Address
Check power supply output with a multimeter. Verify positive and negative terminal positions. Incorrect IP configuration or SW2-1 left ON. lenel lnl3300m5 installation manual upd top
Verify network cable continuity and confirm the switch port is active. To help finalize your system configuration, tell me:
Use resistors for all supervised inputs to monitor for wire tampering.
: Set your computer's IP address to the 192.168.0.x range (excluding .251 ) to match the panel's default IP of 192.168.0.251 . DIP Switch Settings : Configure the communication baud rate for Port 2 (e
This article provides a comprehensive overview of the guidelines, essential wiring practices, and the latest best practices for upgrading to the OnGuard 8.x ecosystem as of 2026. 1. Overview and Key Features
Ensure the M5/M3000 backplane is clean and undamaged. B. Installing the LNL-3300-M5
Observe the . A steady, rhythmic blink indicates that the board operating firmware is running successfully. If a DHCP server is not available, it
Two onboard inputs are available. They can be configured as unsupervised (normally open/normally closed switches) or supervised using dual EOL (End-of-Line) resistor networks (typically 1K or 4.7K ohm resistors based on software settings). Door Position Switch (Door Contact) IN2 (TB2-3 / TB2-4): Request-to-Exit (REX) Device 5. Relay Outputs (TB3)
If the system fails to initialize, use the following steps:
32-bit architecture with up to 15 MB of available on-board flash memory.
| Terminal | Function | |----------|----------| | +12V DC | Power input (regulated 12VDC, 500mA typical) | | GND | Ground | | RS-485 A (DA) | Data + | | RS-485 B (DB) | Data - | | Reader 1 Data 0/D0 | Wiegand D0 | | Reader 1 Data 1/D1 | Wiegand D1 | | Reader 1 LED | Red/Green control | | Reader 1 Tamp | Tamper input | | Reader 2 (same pins) | Second reader |
Search over 1000+ Lessons from our extensive library.
