Jis G3193 Pdf

It serves as the dimensional "rulebook" that other material standards (like JIS G 3101 for structural steel) point to for sizing. Key Features of JIS G 3193

: Limits for both "mill edges" (untrimmed) and "cut edges". Length : Specific to sheets and plates.

Requirements to ensure material consistency and surface quality jis g3193 pdf

Varies based on edge treatments, spanning from 600 mm up to 2,180 mm . Thickness Tolerances and Measuring Rules

Often hosts older versions or previews of the standard. Conclusion It serves as the dimensional "rulebook" that other

The standard provides comprehensive tables and rules for the following:

Use in design and analysis: Structural properties listed in JIS G3193 tables (e.g., section modulus, radius of gyration) are direct inputs to bending, buckling, and shear calculations. Designers must account for manufacturing tolerances specified by the standard when checking fit-up and clearances. and hot-rolled steel strips.

Tolerances vary based on the thickness and width of the material. Below is a summary of standard thickness tolerances for common dimensions: Thickness Tolerances (Typical Values) Specified Thickness (mm) Width < 1600mm Width 1600–2000mm Width 2000–2500mm Under 1.25 plus or minus 0.16 1.60 to < 2.00 plus or minus 0.19 3.15 to < 4.00 plus or minus 0.24 plus or minus 0.34 plus or minus 0.34 10.0 to < 16.0 plus or minus 0.55 plus or minus 0.65 plus or minus 0.65 Measurement Rules Mill Edges : Thickness must be measured at least from the side edge : Thickness must be measured at least from the side edge 🛠 Comparison & Compliance International Equivalent : JIS G 3193 is a modified version ( ISO 7452:2013

Disclaimer: This article is for informational purposes only. Always refer to the official Japanese Standards Association (JSA) documentation for legal binding specifications and the most current revisions.

Hot-rolled steel plates, hot-rolled steel sheets (including cut lengths from strips), and hot-rolled steel strips.