The stands for Heating Element Error . On the Gordak 952, this specific message indicates one of the following:

attached to a heatsink. If it looks charred or shows a short between its legs during a continuity test, replace it.

Trace the wiring loom leading from the main PCB to the hot air handle adapter.

Visually inspect the entire cable from the main unit to the handle. Look for:

A healthy element usually shows a low resistance (often between depending on the specific Gordak model). An "Open" reading ( OLcap O cap L ) confirms the element is blown and needs replacement.

Disclaimer: Ensure you are comfortable with high-voltage electronics before opening your soldering station, and always work with the device unplugged. If you'd like, let me know:

: The most frequent cause is a burnt-out or broken heating element in the hot air wand or soldering handle.

GORDAK 952 heater problem

With the station open and the main power board exposed, you can check for more complex faults. For common faults, refer to the Gordak 952 circuit diagram (schematic) to trace the issue.

: Intermittent "H-E" messages can be caused by loose wiring or pins inside the handle connector.

: Use a multimeter to check the resistance of the heating element wires. Reference the Gordak 952 Manual

Understanding and Fixing the Gordak 952 "HE" Error on Portable Rework Stations

: This could potentially be a brand name or a specific product line. Without more context, it's challenging to provide specific information.